Hey thank you for checking out my listing! These are 3D printed by me using PLA filament and assembled with super glue. 

Each Blowhog is roughly 5 inches long from snout to rear and the body is about 2.5 - 3 inches round. 

Each half is printed and glued together. There is a small crease in the center as shown. I tried to get it right in the skin crease to make it the least amount of noticeable as possible. Since these are 3D printed they may have print lines and minor defects as shown in the pictures. I print them as high quality as I can to minimize the lines.

I have displayed one outside for a few months now and knocked it down and the nose snapped off. But it was a decent fall so I'm not sure if it was more brittle from being outside or if that would have happened anyway. Other than that, the figure itself still looks good. That being said, outdoor display does run the risk of damaging the figure or it becoming brittle from the sun or ruined from water damage. Display outside at your own risk!
 
Thank you for taking the time to browse my shop and check out my other Pikmin inspired 3D prints!